Configuring IGRP
7.3.5 This page will introduce the commands that are used to configure IGRP.
To configure the IGRP routing process, use the router igrp configuration command. To shut down an IGRP routing process, use the no form of this command.
The command syntax is as follows:
RouterA(config)#router igrpas-number
RouterA(config)#no router igrpas-number
The AS number identifies the IGRP process.
To specify a list of networks for IGRP routing processes, use the network router configuration command. To remove an entry, use the no form of the command.
Figure shows an example of how to configure IGRP for AS 101.
The Lab Activities will help students configure IGRP.
The next page will explain how to convert a router from RIP to IGRP.
No comments:
Post a Comment